Fixed 'Enable AMD Fluid Motion Video' setting was gray out when using old display driver.Fixed playback issue when enabling 'Enable support for DXVA decoder' option on Version 4.2.1.Reduced GPU usage when enabling Anti Frame Blend Mode.Added support to convert 24p/25p/30p/60i to 120p and 144p.Added support to set maximum resolution for each output rate.Fixed GPU memory usage kept increasing during frame step when using MPC Video Renderer or madVR with Zero-Copy Mode.Fixed could not use 25p and 30p to 60p conversion on Kaveri APU.Added support for 50p and 60p input rates.Note: In this case, all applications that use the decoder selected in this setting will load BlueskyFRC.ĭisplays the current status of the BlueskyFRC filter. In addition, after turn on 'Enable Global Mode', run video player and specify the decoder selected this setting in the player setting. When impossible to specify any external filter, but possible to specify a specific decoder (LAV Video Decoder or MPC Video Decoder).In this case, turn on 'Enable decode function using external decoder' and specify the decoder to be used as the external decoder. When only a video decoder can be specified as an external filter.However, this option is a useful setting in the following cases. If you can specify BlueskyFRC as an external filter in the video player and it is actually used, you do not need to change this setting. If this happens, change the filter that is causing the problem to a lower mode or 'Auto' or 'Off'. If the GPU does not support the filter, the video may not play properly. Color Filter (Color Vibrance, Color Enhancement).Dynamic Contrast (Non-Adaptive, Content Adaptive).Noise Filter (Temporal NR, MoComp Temporal NR).Sharpness Filter (Edge Enhancement, Detail Enhancement, Resolution Enhancement).You can set the following filters available for Radeon GPU. If these conditions are not met, BlueskyFRC will not be used. Video Renderer and BlueskyFRC use the same GPU.

Video Player use Enhanced Video Renderer, madVR or MPC Video Renderer (Direct3D11).

There is no point to choose 'DXVA2 (copy-back)' when using the same GPU for BlueskyFRC and for LAV Video Decoder. In LAV Video Decoder, please set 'Hardware Decoder to use' to 'DXVA2 (native)'.

For some players, the setting method is explained below. Please setup to use Bluesky Frame Rate Converter in DirectShow Player.

Turn on 'Enable AMD Fluid Motion Video' in 'Device' setting.

Potplayer old version 32 bit